This project was CASED from Angel Buttons AKA Roxie Roo Crafts
its just so cute I had to follow it and do my version.
To make this project I used a sheet of Very Vanilla cardstock cut down to 5 1/2" x 4" ( you get 4 of them from one sheet of A4)
Score your card as follows
On the long side - 1", 2 1/2", 3 1/2", 5"
On the short side - 1", 3"
We are then going to cut into make the right shape.
Cut off the two small rectangles, then cut up from the bottom to the first score line keep the first rectangle straight edges the other 3 are notched to make it fit better.
I then notched the long rectangle also.
On the top section you leave the first rectangle and then cut away the last 3 sections.
I then rounded the corners of the remaining rectangle
It will leave you with the above shape in the photo
Then glue your box together add glue to the long rectangle section
then fold the box up and start to fold in the base, fold in the largest notched rectangle
then the two remaining smaller ones lastly add glue to the remaining straight rectangle and adhere to close your base up.
Using the long section we cut away (scrap piece) punch out a circle
Cut your DSP Layers
you need two panels measuring 1 3/4" x 1 1/4"
and one panel measuring 3/4" x 1 1/4"
I then added a glue dot to the magnet and stuck it on the underside of my flap
I then put the other magnet on top and added a glue dot and folded over the flap to stick the magnet on the front panel so it closes perfectly
Like so and then add tombow to the magnet on the flap and add the small circle over the top
to disguise the magnet
then add tombow to the dsp layers and adhere them to the front and back panel and the small one to the front section.
I then done a few other dsps to add some changes.
Video Tutorial attached Below
Thank you to Angel for the tutorial and Inspiration
Blog
YouTube
Instagram
No comments:
Post a Comment